General Applications:
Wastewater and rainwater drainage
Dewatering
Grain Elevator Pit
Pumping non-fibrous effluents
Industrial, commercial and residential areas
Pumping stations (E / EV 40 models)
Wastewater treatment plants (ETE) (E / EV 40 models)
Technical Details:
BSP threaded nozzle
GG-20 cast iron volute
Noryl 30% Fiberglass vortex semi-open impeller for DV / EV models up to 1 hp
GG-25 cast iron semi-open impeller for models D / E / EV 40
GG-20 cast iron neoprene rubber wear plate for model D
GG-20 cast iron wear plate (E / EV40 models)
Mechanical seal made of AISI-304 stainless steel, Buna N, hard carbon and ceramic for DV / EV models up to 1 hp
Double mechanical seal, made of AISI-304 stainless steel, Buna N, graphite and ceramic for D / E / EV 40 models
IP-68, 2 poles, 60 Hz, electric motor cooled by dielectric oil, AISI-420 stainless steel shaft
Single phase pump with float switch option for automatic operation (DV / EV models)
Single phase pump with thermal protector (DV / E / EV models)
Cable length: 7 m (DV / EV models) and 10 m (D / E / EV 40 models)
Options:
Mechanical Seal: Buna N and Silicon Carbide
Cable length: 25 meters
Important:
The electrical installation must follow the instructions of NBR 5410.
Prohibited use for pumping drinking water.
Install the BCS electric motor and operate completely submerged.
Models that have an electric float for automatic activation should not operate in continuous operation.
For pumping in a continuous system, full submergence of the product is required.
Maximum temperature of the pumped liquid: 40 ° C.
For pumping water with abrasive material, consult Factory.
Refer to the Instruction Manual for other operational precautions.