Dimmers
HQRD-6CL-XX 600 W/VA (Incandescent/Halogen/MLV) or 150 W (CFL/LED)
Two-Wire Dimmer*
HQRD-6D-XX 600 W Two-Wire Dimmer
HQRD-6ND-XX 600 W Neutral Wire Dimmer
HQRD-10D-XX 1000 W Two-Wire Dimmer
HQRD-10ND-XX 1000 W Neutral Wire Dimmer
HQRD-6NA-XX 600 W Neutral Phase Adaptive Dimmer
HQRD-F6AN-DV-XX 6 A Fluorescent/LED 3-Wire Dimmer
HQRD-PRO-XX 250 W (CFL /LED) or 500 W/VA Incandescent/Halogen/ELV or 400 VA MLV
Phase Selectable, Neutral Optional dimmer*
Switches
HQRD-8ANS-XX Neutral Wire Electronic Switch
HQRD-8S-DV-XX Two-Wire Electronic Switch
Fan Speed Control (single ceiling paddle fan only [120 V~])
HQRD-2ANF-XX 2 A Fan Speed Control
Remotes (for multi-location installations)
HQD-RD-XX Remote Dimmer (120 V~)
HQD-RS-XX Remote Switch (120 V~)
HQD-RD-277-XX Remote Dimmer (277 V~) (for use with -F6AN-DV only)
HQD-RS-277-XX Remote Switch (277 V~) (for use with -8S-DV only)
Color Change Kits
RK-D-XX Dimmers (-6CL, -6D, -10D, -10ND, -6NA, -PRO, -F6AN-DV)
RK-S-XX Switches (-8ANS and -8S-DV)
RK-AD-XX Remote Dimmer (-RD)
RK-AS-XX Remote Switch (-RS)
RK-F-XX Fan Speed Control (-2ANF)
* Go to www.lutron.com/ledfinder to see all compatible CFL / LED lamps.
Note: “XX” in the model number represents color/finish code. See Colors and Finishes at end of document.
Model Numbers Dimmer: HQRD-6CL, HQRD-6D, HQRD-6ND, HQRD-10D, HQRD-10ND, HQRD-6NA,
HQRD-F6AN-DV, HQRD-PRO
Switch: HQRD-8ANS, HQRD-8S-DV
Fan Speed Control: HQRD-2ANF
Remote: HQD-RD, HQD-RS, HQD-RD-277, HQD-RS-277
Color Change Kits: RK-D, RK-S, RK-AD, RK-AS
Power 120 V~ 50/60 Hz: -6CL,-6D, -10D, -10ND, -6NA, -2ANF, -8ANS, -RD, -PRO, -RS
120–277 V~ 50/60 Hz: -F6AN-DV, -8S-DV
Typical Power
Consumption
Dimmer/Switch/Fan Speed Control: 0.6 W
Test conditions: load is off and nightlight mode is enabled.
Remote Dimmer/Switch: 0 W
Test conditions: load is off.
Regulatory
Approvals
UL, CSA (all except -6CL, -6NA and -PRO), cUL (-6CL, -6NA, -PRO only), NOM, FCC, IC,
COFETEL, ANATEL (all except -6NA, -6CL and remotes)
Environment Ambient operating temperature: 32 °F to 104 °F (0 °C to 40 °C), 0% to 90% humidity,
non-condensing. Indoor use only.
Communications Dimmers and switches communicate with the HomeWorks system through Radio
Frequency (RF) and must be located within 30 ft (9 m) of a repeater. Remote
dimmers / switches are not required to be within a specific range of a repeater.
ESD Protection Tested to withstand electrostatic discharge without damage or memory loss, in
accordance with IEC 61000-4-2.
Surge Protection Tested to withstand surge voltages without damage or loss of operation, in accordance
with IEEE C62.41-1991 Recommended Practice on Surge Voltages in Low-Voltage AC
Power Circuits.
RTISS Equipped Circuitry compensates in real time for incoming line-voltage variations (neutral
connection required). -PRO only.
Power Failure Power failure memory: should power be interrupted, the control will return to its previous
state when power is restored.
Mounting Requires a U.S. wallbox. 3½ in (89 mm) deep recommended, 2¼ in (57 mm)
deep minimum.
Wiring Use only remote dimmers (-RD/-RD-277) and remote switches (-RS/-RS-277) with
dimmers / switches /fan speed controls. Up to 9 -RD/-RD-277 or -RS/-RS-277 may be
used with controls.
Warranty www.lutron.com/TechnicalDocumentLibrary/warranty.pdf
